Effective Rainfall Calculator

Find how much of the rain that fell actually reaches the roots and replaces irrigation. Use monthly rain for season planning, compared across four standard methods, or a single storm to see how many days you can skip watering.

Effective rainfall calculator

Choose the rain you’re counting
Quick picks

1Rain and method

in

Total for the month, or the long-term average for planning.

Not sure? The default works for most planning; the result compares all four.

%

Share of the rain you count. 70–90 % is common for moderate monthly totals.

2Crop and soil

in

Needed for the USDA-NRCS method; optional otherwise, to show the irrigation still needed. Find it here.

in

Net depth applied per irrigation, about the readily available water. Work it out.

See the effective rain ↓

How the calculator works

Not all rain is useful to plants. Some evaporates from leaves and the surface, some runs off, and some drains below the roots. Effective rainfall is what is left in the root zone.

The monthly mode estimates it from a month’s total with your choice of four standard methods and shows all four side by side. The storm mode credits one rain event, caps it at the room the soil had, and tells you how many days of watering it replaces.

  • USDA-SCS simplified (mm a month)Pe = P × (125 − 0.2 P) ÷ 125 for P up to 250 mm; Pe = 125 + 0.1 P above
  • FAO empirical (mm a month)Pe = 0.8 P − 25 if P is over 75 mm; Pe = 0.6 P − 10 otherwise; never below 0
  • USDA-NRCS (inches a month)Pe = SF × (0.70917 P^0.82416 − 0.11556) × 10^(0.02426 ETc), no more than the rain or ETc
  • Storage factorSF = 0.531747 + 0.295164 D − 0.057697 D² + 0.003804 D³ (D = usable soil storage, 0.75–7 in)
  • Fixed percentagePe = P × your %
  • One stormfirst 0.1 in lost; full credit up to 1 in; two-thirds of the next inch; nothing above 2 in; then the smaller of that and the soil deficit
  • After rainirrigation still needed = ETc − Pe · days replaced = Pe ÷ daily water use, rounded down

Worked examples

A 3-inch month by USDA-SCS

  1. Inputs3.00 in of rain in the month (76.2 mm).
  2. Formula76.2 × (125 − 0.2 × 76.2) ÷ 125 = 66.9 mm.
  3. Result66.9 ÷ 25.4 = 2.63 in, 88 % of the rain.

The same idea with crop use and storage (USDA-NRCS)

  1. Inputs4.00 in of rain, crop water use 6.00 in for the month, usable soil storage 3.00 in.
  2. Storage factorSF = 1.00 at 3 in of storage.
  3. Result1.00 × (0.70917 × 4^0.82416 − 0.11556) × 10^(0.02426 × 6) = 2.95 in (74 %). Irrigation still has to supply 6.00 − 2.95 = 3.05 in.

A summer thunderstorm

  1. Inputs1.60 in of rain; the root zone was 0.80 in short of full; plants use 0.20 in a day.
  2. Credit0.9 + ⅔ × 0.60 = 1.30 in by the rule of thumb, but the soil only had room for 0.80 in.
  3. Result0.80 in counts. 0.80 ÷ 0.20 = 4: skip watering for 4 days, then resume.

FAO vs USDA effective rainfall methods compared

The methods agree on the shape, not the numbers. In a light month FAO counts much less than USDA-SCS; in a very wet month they come together.

Effective rainfall in inches by method. NRCS uses ETc 6.00 in and storage 3.00 in; fixed percentage uses 80 %.
Monthly rainUSDA-SCSFAOUSDA-NRCSFixed 80 %
1 in0.960.210.830.80
2 in1.840.811.601.60
3 in2.631.422.292.40
4 in3.352.222.953.20
6 in4.543.824.184.80
8 in5.405.425.356.40

The USDA-SCS simplified curve is the one FAO’s CROPWAT program offers as “USDA Soil Conservation Service”. The full USDA-NRCS method from the National Engineering Handbook goes further: more crop water use means the soil dries faster and has room for more rain, and more soil storage means less runs through. A fixed percentage is quick but treats a drizzle and a deluge the same. Pick one and use it all season, so months compare fairly.

Should you skip watering after rain, and for how long?

For one storm, the calculator uses a common rule of thumb from the TexasET Network: the first tenth of an inch wets leaves and the surface and evaporates; rain up to 1 in counts fully; two-thirds of the next inch counts; anything over 2 in is lost to runoff and deep drainage. If you think your site does better or worse, choose your own percentage.

Then comes the soil. Rain can only fill the room the root zone had. Enter the soil water deficit, the water used since the last soaking, and the credit is capped there. Divide what counts by the daily water use and you have the days to skip. If the result is 0, keep your normal schedule. The irrigation schedule calculator tracks the deficit for you with its “water used since the soil was full” field.

How soil storage and slope change effective rain

A dry soil with deep roots takes more rain than a wet one with shallow roots. In the NRCS method this is the storage factor: at 3 in of usable storage it is 1.00; at 1 in it falls to 0.77, so a quarter less rain counts; at 7 in it rises to 1.08. Work out your storage with the available water capacity calculator; the readily available water is a good value for D.

Slope and soil intake matter too. The FAO formulas are meant for slopes up to about 4–5 %. On steeper ground or tight clay, more of a heavy rain runs off, so lower the credit with a fixed percentage.

Using effective rain in seasonal irrigation planning

For each month: work out the crop’s water use with the water requirement calculator, subtract the month’s effective rain from here, and the rest is the net irrigation to plan for. Divide by system efficiency for the gross. Use long-term average rain for planning, and actual rain for the season you are in.

How to read your result

What the share of rain that counts tells you.
ResultWhat it meansWhat to do
Under 40 % countsMost of the rain is lost: very light rain, or heavy rain that ran off or drained.Don’t cut irrigation much.
40–80 %Typical; a good part of the rain counts.Subtract the effective rain from the need.
Over 80 %Nearly all counts: steady, moderate rain on a dry soil.Subtract it and skip waterings to match.
Storm: 0 countsToo little to reach the roots.Keep your normal schedule.
Storm: cappedThe soil filled up; the rest drained or ran off.Count only the deficit.

How we build and check this calculator

Each method on this page names its source, and the code is tested against worked cases, including the FAO manual’s own numbers, before every update.

  • Methods from recognised sources. The FAO formula follows FAO’s irrigation water management manual; the USDA-NRCS method follows the National Engineering Handbook, Part 623; the USDA-SCS curve follows the CROPWAT method; the storm rule follows the TexasET Network. See the sources.
  • Tested against worked cases. Nine test cases run against the calculator code before every update: the FAO manual’s 90 mm and 35 mm months, a USDA-SCS month and its high-rain branch, two NRCS months with different storage, a fixed percentage, three storm sizes, a capped storm and a drizzle. All must match.
  • Honest about limits. Monthly methods describe long-term averages, not a single month’s storms. Intensity, slope, crusting and a full soil can make real effective rain much lower.
  • Your entries stay on your device. The calculator runs in your browser. Nothing you type is sent anywhere; your inputs live only in the page address, so you can bookmark or share a result.
  • Corrections are welcome. If a number looks wrong, tell us. We check it against the sources, fix the page and update the date at the top.

Page history

Published. Methods, test cases and source links checked.

Questions

What is effective rainfall?

It is the part of the rain that soaks into the root zone and stays there for plants. The rest is lost to evaporation from leaves and the surface, runoff, or drainage below the roots. It is also called effective precipitation.

How much rain counts as watering a lawn?

As a rule of thumb, rain under about 0.1 in mostly evaporates and does nothing for the roots. Rain between 0.1 and 1 in counts almost fully. Above 1 in, more and more runs off or drains, and above about 2 in very little extra counts.

Should I skip watering after rain, and for how long?

Divide the rain that counts by your plants’ daily water use. A storm that puts 0.8 in into a dry root zone covers 4 days at 0.2 in a day. If the soil was already near full, only the room that was left counts.

Which effective rainfall method should I use?

For planning, the USDA-SCS simplified formula is a sound default. Use the USDA-NRCS method when you know the crop’s monthly water use and the soil storage, because it accounts for both. The FAO formula is conservative in light-rain months. Whichever you choose, use the same one all season.

Why do FAO and USDA methods give different answers?

They were fitted to different data and make different assumptions. FAO’s empirical formula subtracts a fixed loss, so a light month counts little. The USDA-SCS curve credits most of a light month. The NRCS method rises with crop water use and soil storage. At 3 in a month they give 1.42 to 2.63 in.

Do light showers or heavy storms count more?

Steady, moderate rain counts best. Light showers wet leaves and the surface, then evaporate. Heavy downpours fall faster than the soil can take water in, or fill the root zone and drain past it.

How do I use effective rain in seasonal irrigation planning?

Work out each month’s crop water use, subtract that month’s effective rain, and plan irrigation for the rest. Start with the water requirement calculator for the crop’s use.

Sources

  1. Food and Agriculture Organization of the United Nations (FAO), Irrigation Water Management Training Manual: Chapter 4, Irrigation Water Needs (S2022E). The FAO empirical formulas (0.8 P − 25 above 75 mm a month, 0.6 P − 10 below), their worked values (90 mm → 47, 35 mm → 11) and the 4–5 % slope limit.
  2. USDA Soil Conservation Service (now NRCS), National Engineering Handbook, Part 623, Chapter 2: Irrigation Water Requirements (1993). Equation 2-84 for average monthly effective precipitation from rain and crop water use, and the soil water storage factor (equation 2-85), tabulated for storage from 0.75 to 7.0 in.
  3. Spanish Ministry of Agriculture, Fisheries and Food (SIAR network), Precipitación efectiva (effective rainfall methods). Sets out the USDA-SCS simplified formula used in FAO’s CROPWAT software, P × (125 − 0.2 P) ÷ 125 below 250 mm a month and 125 + 0.1 P above.
  4. Texas A&M AgriLife Extension, TexasET Network, Effective Rainfall. The tiered default for single rain events used in the event mode; the page gives no underlying source, so we label it a rule of thumb.
  5. Texas A&M AgriLife Extension, Watering Your Vegetables (EHT-024). Garden-scale correction factors showing how little of a light rain counts.
  6. University of Florida IFAS Extension, Evapotranspiration-Based Irrigation for Agriculture: Implementing Evapotranspiration-Based Irrigation Scheduling for Agriculture (AE458). A worked monthly schedule that subtracts effective rain from crop water use.
  7. The soil-deficit cap, the days of watering replaced and all unit conversions are derived on this page.

Links checked November 15, 2026. The USDA-SCS simplified constants were checked against the CROPWAT method as published by the SIAR network, and the NRCS constants against NEH Part 623, Chapter 2.