All Irrigation Calculators

Every calculator on Irrigation Calc, grouped by job. Each one shows its formula, a worked example, its sources and the date it was last checked, and works in US or metric units.

Start with your project

Browse by category

What every calculator page shows

A number you can’t check is hard to trust. So every calculator here shows its working, not just an answer.

  • The formula and a worked example. Follow the math by hand with real numbers.
  • What the result means. Each answer is rated against typical ranges, with what to do next.
  • Sources and assumptions. Linked references, and a plain list of what the calculator assumes.
  • Private by design. The math runs in your browser; inputs stay in the page address so you can share a result.

How the categories fit together

  1. Water needsHow much water the plants use and when to apply it. Water needs calculators.
  2. Sprinkler and dripLaying out heads and emitters to deliver that water evenly. Sprinkler and drip calculators.
  3. HydraulicsGetting enough flow and pressure to every head. Hydraulics calculators.
  4. Water costsWhat the water, energy and hardware cost. Water cost calculators.
  5. FarmThe same questions at field scale, in acre-inches and cfs. Farm irrigation calculators.

Units and rounding

The calculators use exact conversion factors and show results rounded to a sensible number of digits. Field guides often round: 1 acre-inch is 27,154 gallons (often 27,200), 1 cfs is 448.83 gpm (often 450), and one inch over a square foot is 0.623 gallons. Where a published example uses a rounded factor, the calculator page says so. Convert any farm unit with the acre-inch converter.

How we build and check our calculators

Each calculator starts from published methods, is coded in base units, and is tested against worked examples in US and metric units before it goes live and after every change. When a source’s own example uses rounded numbers, we say where our exact result differs. Read the full process in our editorial policy, and tell us if anything looks wrong.

Questions

Are these irrigation calculators free?

Yes. Every calculator is free to use with no sign-up, and it runs in your browser, so nothing you type is sent to us.

Can I use metric units?

Yes. Every calculator has a US and a metric setting, and it remembers your choice on your device.

Where do the formulas come from?

From university extension services, the FAO, the U.S. Bureau of Reclamation, the Irrigation Association and published manufacturer engineering data. Each calculator page lists its sources with links.

How accurate are the results?

The math is tested against worked examples before every update, but the answer is only as good as the inputs. Results are planning estimates; measure your own system where you can.

Can I share a result?

Yes. Your inputs are saved in the page address, so you can bookmark the page or send the link and it opens with the same numbers.

Can I suggest a calculator?

Yes, please do. Use the contact page to suggest a calculator or report a number that looks wrong.

Sources

  1. Food and Agriculture Organization of the United Nations (FAO), Crop Evapotranspiration, Irrigation and Drainage Paper 56. The ET method behind the water needs calculators.
  2. Irrigation Association, Using Distribution Uniformity to Evaluate the Quality of a Sprinkler System. Distribution uniformity and scheduling.
  3. U.S. Bureau of Reclamation, Water Measurement Manual — Conversion factors. Water volume and flow conversions.
  4. Kansas State University Research and Extension, Irrigation Formulas and Conversions (MF-2404). Irrigation formulas used across several calculators.

Links checked November 16, 2026. These are the references used most often; each calculator page lists its own full set.